This guide will provide step-by-step instructions on how to perform a factory reset for your Nexar Beam dash cam.
How to Factory Reset on Your Nexar Beam
Follow these simple steps to perform a factory reset on your Nexar Beam:
1. Connect the dash cam to a power source.
2. Press the Power button on the dash cam 9 times. You should hear a clicking sound whenever you press the button.
3. Wait for the voice prompt to instruct it, then press the Power button again.
4. You will hear a voice prompt that says “The factory settings have been restored”.
5. The dash cam will reboot after a successful reset.
Important Reminder
These steps apply specifically to the Nexar Beam dash cam. If you are using a different Nexar dash cam model, please check your dash cam's respective support page in our Help Center for guidance.