This guide will provide step-by-step instructions on how to perform a factory reset for your NEXC1 dash cam.
Follow these simple steps to perform a Factory Reset on your NEXC1
First, open your Nexar Classic > Tap More > Tap Help and on this page, check out the firmware version of your NEXC1 and follow the corresponding steps below.
NEXC1 With Firmware Version 1.2.0 and 1.2.8
Here are the steps on how to perform a factory reset for NEXC1 dash cams with firmware versions 1.2.0 and 1.2.8:
1. Connect the dash cam to a power source.
2. Press and hold the Power button of the dashcam for 15-20 seconds or until it turns off
3. Wait until the dash cam turns back on.
4. After the reboot, the red light should be flashing. If the red light is steady, press the Power button once quickly.
NEXC1 With Firmware Version 1.3.2 and Above
Here are the steps on how to perform a factory reset for NEXC1 dash cams with firmware versions 1.3.2 and above:
1. Connect the dash cam to a power source
2. Press the Wi-Fi button 9 times, then press it once more for confirmation. You should hear a clicking sound and a voice prompt confirming the reset.
3. Wait for the voice prompt to instruct it, and press the Wi-Fi button again.
4. You will hear a voice prompt that says “The factory settings have been restored.”
5. The dash cam will reboot after a successful reset.
These steps apply specifically to the NEXC1 dash cam. If you are using a different Nexar dash cam model, please check your dash cam's respective support page in our Help Center for guidance.